Ram Movement
The ram travels forward/backward 11" and rotates
180° on the turret.
Tools Needed
Wrench 15mm ................................................... 1
Wrench 24mm ................................................... 1
Moving Ram Forward/Backward
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen the two lock handles shown in
Figure 19.
Lock Handles
Pinion Gear Bolt
Figure 19. Ram back-and-forth controls.
3.
Rotate pinion gear bolt to move ram until
spindle is in desired position.
4.
Retighten lock handles to secure ram move-
ment vbefore resuming operation before
resuming operation.
Model G0757 (Mfg. Since 6/13)
Rotating Ram On Turret
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen the four hex nuts (two on each side
of the ram) that secure ram to turret (see
Figure 20).
Qty
Figure 20. Ram rotation hex nuts
3.
Make sure that cables and hoses are not
entangled or stretched as you move ram on
turret.
4.
Retighten the four hex nuts that secure the
ram on turret before resuming operation.
Hex Nuts
(2 of 4)
(left side shown).
-27-