Head Tilt; Table Rotation - Grizzly G0757 Owner's Manual

Table Rotation

The table rotates 45° left or right (see Figure 17).
Hex Nuts
(2 of 4)
Figure 17. Table rotated 45° to the right.
Tool Needed
Wrench 19mm ................................................... 1
To rotate the table:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove as many items from table as pos-
sible. This makes rotating the table easier.
3.
Loosen the four hex nuts that secure table to
knee (see Figure 17).
Note: There are two hex nuts behind the
table as well.
4.
Using the angle scale on knee as a guide,
rotate table to desired position.
5.
Retighten the four hex nuts that secure table
to knee before resuming operation.
-26-
The head tilts 90° left or right at the end of the
ram.
Tools Needed
Wrench 19mm ................................................... 1
Wrench 24mm ................................................... 1
To tilt the head:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen the three hex nuts (one on each side
of head and one underneath) that secure
head to ram (see Figure 18).
Qty
Figure 18. Head tilting controls.
3. With assistance from another person to sup-
port the head, turn tilting bolt until head is in
desired position.
Note: Use the angle scale shown in Figure
18 as a guide for setting tilt angle.
4.
Retighten hex nuts that secure head to ram
before resuming operation.
When tilting the head back to 90°, you
will need to tram it to ensure the spindle
is perpendicular to the table. Refer to the
Tramming the Mill section on Page 34 for
detailed instructions.

Head Tilt

Scale
Hex Nut
(1 of 3)
Model G0757 (Mfg. Since 6/13)
Qty
Tilting
Bolt