Single Trigger - Owon SDS1022 User Manual

Single Trigger

Single trigger has two types: edge trigger, video trigger.
Edge Trigger: It occurs when the trigger input passes through a specified voltage level
with the specified slope.
Video Trigger: Trigger on fields or lines for standard video signal.
The two trigger modes in Single Trigger are described respectively as follows:
1. Edge Trigger
An edge trigger occurs on trigger level value of the specified edge of input signal. Select
Edge trigger mode to trigger on rising edge or falling edge.
Push the Trigger Menu button to display the Trigger menu on the right. Select Type as
Single in the right menu. Select Single as Edge in the right menu.
In Edge Trigger mode, the trigger setting information is displayed on bottom right of the
screen, for example,
source is CH1, coupling is DC, and trigger level is 0.00mV.
Edge menu list:
Menu Settings
Type Single
Single Edge
CH1
Source
CH2
Auto
Mode Normal
Single
Next Page
AC
Coupling
DC
Slope
Holdoff
Holdoff
Reset
Prev Page
Trigger Level: trigger level indicates vertical trig position of the channel, rotate trig level
knob to move trigger level, during setting, a dotted line displays to show trig position, and
the value of trigger level changes at the right corner, after setting, dotted line disappears.
2. Video Trigger
4.Advanced User Guidebook
，indicates that trigger type is edge, trigger
Instruction
Set vertical channel trigger type as single trigger.
Set vertical channel single trigger type as edge trigger.
Channel 1 as trigger signal.
Channel 2 as trigger signal.
Acquire waveform even no trigger occurs
Acquire waveform when trigger occurs
When trigger occurs, acquire one waveform then stop
Enter next page
Block the direct current component.
Allow all component pass.
Trigger on rising edge
Trigger on falling edge
100 ns - 10 s, turn the M knob to set time interval
before another trigger occur.
Set Holdoff time as default value (100 ns).
Enter previous page
25