Xy Modulator Pad - 1010music nanobox | fireball User Manual

nanobox | fireball User Guide v 1.0.10

XY MODULATOR PAD

The XY Modulator Pad allows you to use touch gestures and knobs to control the X and Y
modulation sources. Each factory preset is configured to map the X and Y modulators to
one or more parameters that will add interesting dimension to the sound. The XY pad
only affects sounds that are currently playing. Trigger a note with the Hold function on
the Grid Keyboard screen, and then push the Layer button to jump over to the XY
Modulator Pad to perform live audio modulations. These are the same XY modulators
shown and controlled on the Dashboard.
From the Dashboard, push the Home button to toggle to the XY Modulator Pad. From
the Grid Keyboard, push the Layer button to toggle to the XY Modulator Pad.
To hear the XY Modulators in action, load the preset 095Windy. In this preset, the X
modulator is mapped to WT1 Position, Filt1 Resonance and Cutoff, and LFO1 Rate. The Y
modulator is mapped to WT2 Position, Filt2 Center Frequency and Q, and LFO2 Rate. Use
the Hold button and trigger some notes on the Grid Keyboard, then push the Layer
button to go to the XY Pad. Drag your finger slowly in one direction at a time and hear
how the sound evolves.
SEE AND TOUCH
XY Pad
XY Pad
Touch the screen to move the X and Y modulator values. You can tap to make a
momentary change, or hold and drag for longer, sweeping changes. Drag left and right
to control the X modulator, up and down to control the Y modulator.
Page 16 of 55
0,0
Current
Point
Position
Feb 8, 2022
Fallback
Position
Copyright 1010music LLC 2022