Safety Symbol Summary - Generac Power Systems MAGNUM MMG75D Operating Manual

Safety
You can also obtain other information about motor vehicle safety from http://www.safercar.gov.

SAFETY SYMBOL SUMMARY

The safety and operating decals affixed to the unit provide important instructions and warn of dangers and hazards.
Replace any missing or hard-to-read decals and use care when washing or cleaning the unit. Decal placement and
part numbers can be found in the online parts manual at www.generacmobile.com. Below is a summary of the
intended meanings for the symbols used on the decals.
Safety alert symbol; used to
alert you to potential personal
injury hazards.
Hot surface(s) nearby.
Belt/entanglement hazard; keep
body parts clear of this area.
Fan hazard; keep body parts
clear of this area.
Never change switch position
while engine is running.
Stop engine before making
connections.
Stop engine before fueling.
Hearing protection required
while operating unit with doors
open.
Lift here only.
Engine running.
Exhaust Filter Cleaning enabled.
4
Figure 1-1. Safety Symbol Summary
MMG75D-100D Operating Manual
Asphyxiation hazard; operate
in well ventilated area.
Dangerous voltage may be
present.
Anchor/tie down point.
Isolate generator to prevent
electrocution hazard.
Use clean diesel fuel only.
Remove negative battery
cable before performing
any service on unit.
Read and understand the
supplied operator's manual
before operating unit.
Unit electrical ground.
Fire/explosion hazard; keep
open flames away from unit.
Burn/scald hazard;
pressurized steam.
Exhaust Filter Cleaning disabled.
00383
33701 C