Weco cad III Operation Manual page 39

Test pattern in loop test okay.
E 43
Test pattern in loop test faulty.
E 44
The monocular PD value is less than
E 46
half the DBL value. Therefore the
decentration point is outside the form.
Timeout – time elapsed during loop
E 47
test.
The following errors only occur in connection with the system components Optolab 1 and
Pollingbox /Pollingcard:
Error
message
E 57 Form number is already occupied
when transmitted to the PC.
Requested form number not available
E 60
in files.
Data set transmitted to PC is faulty,
E 61
e.g. contour is not closed.
E 62 Transmission error during reception in
the Pollingbox /Pollingcard or the PC.
Message meaning
Press <C> key .
Press <C> key .
Press <C> key, enter correct value.
Press <C> key .
Correction
Press <C> key , enter new form
number and send again.
Press <C> key – check form number,
request again.
Press <C> key – request form again
and repeat decentration and
transmission.
Press <C> key – request form again
and repeat decentration and
transmission.
39