First Test Run; Address Setting - Weco cad III Operation Manual

4.4 test run
First

4.5 address setting

CAL
CH
ENTER
7 8
9
4 5 6
1 2 3
0
ENTER
CAL
16
•
Switch on all devices (FormTracer, CAD 2000 and
edgers).
•
Trace the form on the Form Tracer
•
Call form on CAD2000.
The traced form is displayed.
When error messages appear (see 8.2)
Address changes are only required when two machines are used with the
same address.
Factory settings:
Note : Do not use divices with the same address in the
same system!
•
Switch-on device
% Press <CAL> key, the calibration menu is displayed
% Press <CH> key
% Press <decimal point> key change menu is displayed.
Note: Do not change the x and y values. A wrong blocking
point will result!
% Press <ENTER> key until cursor is on CL3
% Enter address on key pad.
Allowed address values:
For use with SM200:1 - 5
For use with OPTOLAB:
% Press <ENTER> key
% Press <CAL> key to end functionn
FormTracer
CAD 2000
Edger
1 - 24
Address 1
Address 3
Address 4