Operation; Getting Started - Weco cad III Operation Manual

5 Operation

5.1 Getting started

NEW JOB
1.
MODE
2.
7 8
9
4 5 6
2
1 3
0
3.
ENTER
4.
7 8
9
4 5 6
2
1 3
0
5.
BLOCK
6.
R/L
7.
The normal job processing with the CAD 2000 is very easy to learn
% press <NEW JOB>
% Key <MODE> For single or multi focal lenses.
Display " S " Single vision
Display " M "Multi focal
Display " P " Progressive
% Enter the form number on the key-pad
% Press <ENTER>.
The form of the right lens appears on the screen
% Enter the decentration data.
•
Press <ENTER>
Decentration point and lens diameter are automatically calculated
and displayed
•
Place the lens on the lens support.
% Press <BLOCK> to put the table in the parallax free position
•
For single vision lenses place the optical centre of the lens in line with
the centering cross on the screen. For multifocal lenses place the
centre and the edges of the top of the near segment in line with the
markings of the segment on the screen
•
Put the Vario Block in the adapter of the blocking device.
•
Position the blocking device on top of the lens
•
The lens is blocked automatically
% Press <R/L> key to select the left lens.
The left form is displayed decentration values of the right lens
are used.
•
You can over write the data or confirm the data by pressing the
<ENTER> key.
•
Proceed as under point 5.
17