Error Messages - Weco cad III Operation Manual

8.2 Error messages

Error
message
The entered drilling coordinate lies
E 01
outside the allowable range.
The distance of the drilling coordinate
E 02
is less than 1 mm to the edge.
E 03 The distance between 2 drill holes is
less than 1 mm.
E 05 The X or Y decentration value is too
high, the decentration point is located
outside the form.
Decentration values X or Y in menu
E 06
1D are zero.
Timeout - Time error when requesting
E 07
a form out of the CAD2000 memory.
No form available.
After entry of the form number the
<ENTER> key was not pressed
Upper drilling limit reached (menu 4).
E 08
E 09 Lower drilling limit reached (menu 4).
E 10 The drill hole does not lie in the
represented graphic area (menu 4).
Transmitted sides 1 and 3 are not
E 15
equal.
The value for m is smaller than the
E 16
total of the A measurement and the
DBL. This results in a negative DBL
value.
E 18 Use small clamping piece.
E 40 No CL connection available.
Transmission error while transmitting
E 41
a data set.
Transmission error while receiving a
E 42
data set.
38
Message meaning Correction
Press <C> key – Select drilling
coordinate inside the allowable range.
Press <C> key – this message is to
be understood as warning.
Press <C> key – this message is to
be understood as warning.
Press <C> key – enter a smaller /
higher value.
Press <C> key – enter correct
decentration value.
Press <C> key – repeat entry.
Press <C> key – Trace form, Repeat
entry.
Press <C> key, repeat entry,
Press <ENTER> key
Press <C> key – change entry using
the cursor keys.
Press <C> key – change entry using
the cursor keys.
Press <C> key – change entry using
the cursor keys.
Press <C> key – request form again.
Press <C> key, enter correct value.
Press <C> key (menu 1-3).
Press <C> key – change entry using
the cursor keys (menu 4).
Press <C> key – check cabel
connection, switch on master.
Check CL-address for conflicts,
change as necessary.
Check CL-address for conflicts,
change as necessary.