4 Set-up
4.1 Installation
4.2 Electrical connection
4.3 Connection of othe CMS units
•
Open top of cardboard box
•
Remove machine with foam wrap (upwards)
•
Place the machine side ways on a soft underground and remove
packing material
•
Position the machine in such a way that the highest
productivity is ensured..
Note: :
Do not expose the device to direct sunlight, heating
For correct operating temperature see chapter 3.6.
Note:
Please follow safety guidelines (see 1).
•
Check wether the voltage indicated on the WECO type plate is
conform with the local power supplier.
•
Connect the power supply cable at the back side of the
CAD2000.
•
Connect the power supply cable with a correctly installed socket.
•
Switch on the machine.
•
Connect CMS units with interface cable
•
Secure the plug with the screws
systems etc.
15