Power Connection - UTStarcom CDM-7025 User Manual

BATTERY USAGE
(BATTERY REMOVAL)
1.
Pull down the release latch, lift up the battery cover.
2.
Remove the battery from the handset.
Note
If the battery is not correctly placed in the compartment,the
handset will not turn on and/or the battery may detach during use.
15
(BATTERY CHARGING)

POWER CONNECTION

1.
Plug the AC Charger into a standard outlet.
2.
Plug the other end of the AC Charger into the bottom of your
phone. The battery must be installed onto the phone.
• When you charge the battery with the phone power off, you
Hot Key
will see a charging status screen. You cannot operate the phone
until it is powered on.
• The battery is not charged at the time of purchase.
• Fully charge the battery before use.
• It is more efficient to charge the battery with the handset powered
off.
• The battery must be connected to the phone in order to charge it.
• Battery operating time gradually decreases over time.
• If the battery fails to perform normally, you may need to replace
the battery.
BATTERY USAGE
16