UTStarcom CDM-7025 User Manual page 45

VOICE SIGNAL COMMANDS
TRAIN VOICE
Train Voice is the process of optimizing the voice recognition software
to your voice. Train Voice requires that you make recordings of your
voice, which are then used to customize the voice recognition system.
This will take a few minutes and you should be in a quiet environment
for optimum training.
1.
Press OK KEY [MENU], then select "Settings & Tools" menu,
press 8 KEY "VR Settings".
2.
Select 2 KEY "Train Voice".
3.
Select "Train Words" or "Train Digits" with the Navigation Key.
4.
Press OK KEY to save it.
89
VOICE SIGNAL COMMANDS
PROMPT
The prompts settings, "Mode", "Timeout', and "Speed" settings will
allow you to set how you are notified by the voice command system,
the duration in which you can respond, and how fast the System will
play the prompts to you, when in Prompts or Readout mode.
1.
Press OK KEY [MENU], then select "Settings & Tools" menu,
press 8 KEY "VR Settings".
2.
Select 3 KEY "Prompt".
3.
Select "Mode" or "Timeout" with the Navigation Key.
• Mode: Select "Prompts" or "Ring Only".
• Timeout: Select "5 seconds" or "10 seconds".
4.
Press OK KEY to save it.
90