Saving, Displaying And Deleting Measurements - Beurer BM 47 Instruction Manual

• Before the measurement, the last saved test result is
briefly displayed. If there is no measurement in the mem-
ory, the instrument always displays the value "0".
• The cuff is pumped up. Cuff air pressure is released slowly.

6.5 Saving, displaying and deleting measurements

• The results of every successful measurement are stored
together with the date and time. If there are more than 30
measurements, the oldest measurements are lost.
• Press the - or + function button. Select the desired user
memory ( ... ) by pressing the -/+ function button.
Confirm your selection with the START/STOP button
• If you press the memory button M, the average value A of
all the stored measured values in the user memory will be
displayed. If you press the memory button M again, the
average value of the morning measurements for the last 7
days will be displayed. (morning: 5.00 – 9.00, display AM ).
If you press the memory button M again, the average
value of the evening measurements for the last 7 days
will be displayed. (evening: 18.00 – 20.00, display PM ).
If you continue to press the memory button M, the most
recent individual measured values are displayed in turn
with the date and time.
• You can delete the memory by pressing and holding the
memory button M for 3 seconds.
• To switch off, press the START/STOP button
• If you forget to switch off the unit, it will switch off auto-
matically after 1 minute.
NOTE:
This monitor will re-inflate automatically if the system de-
tects that your body requires more pressure for measure-
ment. As soon as a heart rate is detected, the heart rate
symbol is displayed.
• When the measurement is completed the cuff will deflate
entirely. Heart rate, systolic and diastolic blood pressure
are displayed.
. • You can interrupt measurement at any time by pressing
the start/stop button
• _ appears if it has not been possible to perform the
measurement properly. Observe the section on error mes-
sages/troubleshooting and repeat the measurement.
• The test result is saved automatically.
• To switch off and release the pressure, press the start/
stop button
vice, it switches off automatically after approx. 1 minute.
Wait at least 5 minutes before taking another measurement.
.
18
.
again. If you forget to switch off the de-