Industry Canada Notices: Deployment In Canada; Rdl-3000-Rmc; Table 79: Ic: Rdl-3000-Rmc Recommended Safe Distances - Redline RDL-3000 Series Product Manual

RDL-3000-RMC/E/F

5.2 Industry Canada Notices: Deployment in Canada

5.2.1 RDL-3000-RMC

Deployment in Canada
This Class B Digital apparatus meets all the requirements of the Canadian Interference-
Causing Equipment.
The following notices about deployment in Canada are included in training and
documentation provided to professional installers and operators of the final product:
The final product must be professionally installed.
1.
WARNING -- IC RF Exposure Warnings
2.
To satisfy IC RF exposure requirements for RF transmitting devices, the following
distances should be maintained between the antenna of this device and persons
during device operation:
Frequency (MHz)
To ensure compliance, operation at closer than these distances is not
recommended. The antenna used for this transmitter must not be collocated in
conjunction with any other antenna or transmitter.
The RDL-3000-RMC has been designed to operate with an antenna having a maximum
gain of 32 dBi. Antenna having a higher gain is strictly prohibited per regulations of
Industry Canada. The required antenna impedance is 50 ohms.
This device has been designed to ensure that radio frequency emissions are maintained
within the band of operation under all normal operating conditions listed in this manual.
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions:
This device may not cause interference, and
1.
This device must accept any interference, including interference that may cause
2.
undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropic radiated power (EIRP) is not more than
that required for successful communication.
Users should also be advised that high-power radars are allocated as primary users (i.e.
priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars
could cause interference and/or damage to LE-LAN devices.
Déploiement aux le Canada
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Les avis suivants à propos du déploiement au Canada sont inclus dans la formation et la
documentation fournies aux installateurs professionnels et les opérateurs du produit
final:
Le produit final doit être installé par un professionnel.
1.
70-00184-03-02
PRODUCT MANUAL

Table 79: IC: RDL-3000-RMC Recommended Safe Distances

Deployment
4900
5300
5400
5800
Proprietary Redline Communications © 2013
Separation Distance
PMP 260 cm (103") or more
PMP 20 cm (7.8") or more
PMP 20 cm (7.8") or more
PMP 20 cm (7.8") or more
Page 46 of 50 April 30, 2013