Table of Contents
Advertisement
WiFly EXR QA12Bar IP
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-
Slave setup. In a Master-Slave set up one unit will act as the control-
ling unit and the others will react to the controlling units built-in pro-
grams. Any unit can act as a Master or as a Slave however, only one
unit can be programmed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the
unit. Use standard XLR data cables to link your units together.
Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. Set the "Master" unit to your desired mode of operation.
3. On the "Slave" units press the MODE button until "Slave Mode" is
displayed. The unit is now set as the "Slave" unit. Each slave unit
must be set to the same setting.
4. Connect the first "Slave" unit to the "Master", and the "Slave" unit
should now start to follow the "Master".
ADJ Products, LLC - www.adj.com - WiFly EXR QA12Bar IP User Manual Page 14
Master-Slave Configuration
WiFly EXR QA12Bar IP
With this feature you are able to control the unit with DMX without the
need of XLR cables. Your DMX controller must be connected to a ADJ
WiFly Transceiver to use this function. You are able to communicate
up to 2500 feet/760 meters (open line of sight).
1. Follow the instructions on page 12 to set the WiFly address and to
activate WiFly. The address must match the address set on the
WiFly WiFly Transceiver. Note: WiFly address 15 operates in a
receive only state.
2. After you have set the WiFly address, follow the DMX instructions
on page 9 to select your desired DMX Channel mode and set
your DMX address.
3. Apply power to the ADJ WiFly Transceiver. The fixture must be set
up first before you apply power to WiFly Transceiver.
4. If everything is set up properly and the fixture is receiving a
Wireless signal, you should now be able to control it with a DMX
controller.
WiFly EXR QA12Bar IP
This feature will let you link units to run in a master-slave mode with-
out the use of XLR cables.
1. Follow the instructions on page 12 to set the WiFly address and to
activate WiFly. The addresses on each fixture must be the same.
Note: WiFly address 15 acts in a operates in a received only
state.
2. After you have set the WiFly address, select your "Master" unit
and set your desired operating mode.
3. For the "Slave" unit(s), put the unit in Slave mode. See page 14
Master-Slave configuration when setting the unit as a Slave.
4. If everything is set up correctly, the "Slave" units will start follow-
ing the "Master" unit.
ADJ Products, LLC - www.adj.com - WiFly EXR QA12Bar IP User Manual Page 15
WiFly Set Up
WiFly Master-Slave Set Up
Advertisement
Table of Contents
