Master-Slave Set Up - ADJ FOCUS SPOT 4Z User Instructions

Focus Spot 4Z
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-Slave set-up. In a Master-Slave
set up one unit will act as the controlling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Master or as a Slave however, only one unit can be programmed to
act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units together. Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain (master) will use the female XLR
connector only. The last unit in the chain will use the male XLR connector only.
2. Connect the first "Slave" unit to the "Master."
3. Master Unit:
• Press the MODE button to access the main menu. Press the UP or DOWN buttons so that "Function" is
highlighted, then press ENTER.
• Press the UP or DOWN buttons until "Disp.Set" is displayed, press ENTER.
• Press the UP or DOWN buttons until "Auto. Prog" is displayed, and press ENTER.
• Either "Master" or "Alone" will be displayed. Use the UP or DOWN buttons to highlight "Master".
• Press the ENTER button to confirm your selection.
4. Slave Unit(s):
• Press the MODE button to access the main menu. Press the UP or DOWN buttons so that "Function" is
highlighted, then press ENTER.
• Press the UP or DOWN buttons until "Disp.Set" is highlighted, then press ENTER.
• Press the UP or DOWN buttons until "Slave Set" is highlighted, then press ENTER.
• Either "Slave 1", "Slave 2", or "Slave 3" will be displayed. Use the UP or DOWN buttons to find your desired
slave setting.
5. Press the ENTER button to confirm your selection.
ADJ Products, LLC - www.adj.com - Focus Spot 4Z User Manual Page 27

Master-Slave Set Up