Unit Of Measure; Data Speed; Output Sentences - Standard Horizon Eclipse GX1400GPS Owner's Manual

11.4.5 Unit Of Measure

This menu item sets the display units of speed, distance and altitude.
[ ]  "SETUP"  "GPS SETUP"  "UNIT OF MEASURE"
1.
2. Press the [▲] or [▼] key to select the item to be
set, then press the [SELECT] soft key.
3. Press the [▲] or [▼] key to select the unit.
4. Press the [ENTER] soft key to store the new
setting.
5. Press the [CLR] key to return to radio operation.

11.4.6 Data Speed

This menu is utilized to set the NMEA 0183 baud rate of the GPS input (Yellow
and Green wires) and DSC output (White and Brown wires). The default setting
is 4800 bps.
When 38400 bps is selected the DSC sentences (DSC & DSE) are output on
the White and Brown wires after a DSC distress, position request is received.
[ ]  "SETUP"  "GPS SETUP"  "BAUD RATE"
1.
2. Press the [▲] or [▼] key to select the desired
speed from "4800bps" and "38400bps".
3. Press the [ENTER] soft key to save the new
setting.
4. Press the [CLR] key to return to radio operation.

11.4.7 Output Sentences

This selection is utilized to set the NMEA output sentences of the transceiver.
By default, the "GLL" and the "RMC" sentences are turned "ON".
[ ]  "SETUP"  "GPS SETUP"  "NMEA OUT"
1.
72
UNIT OF MEASURE
SPEED kts
DISTANCE nm
ALTITUDE ft
BACK ENTER
SPEED
knot
mile/h
km/h
BACK ENTER
BAUD RATE
4800bps
38400bps
BACK ENTER