Transmit Time-Out Timer ( Tot ); Basic Operation Of The Setup Menu - Standard Horizon Eclipse GX1400GPS Owner's Manual

To switch the TX output power:
1. Press the [H/L] key on the front panel or the micro-
phone to switch between HI (25 W) or LO (1 W)
output power.
NOTE: When the TX output power is set to "Low"
while the transceiver is on channel 13 or 67 (USA
Channel group only), the output power will tempo-
rarily switch from "Low" to "High" power until the
PTT switch of the microphone is released. This
soft key is not function on transmit inhibited and
low power only channels.

9.4 TRANSMIT TIME-OUT TIMER ( TOT )

When the PTT switch on the microphone is held down, transmit time is limited
to 5 minutes. This limits unintentional transmissions due to a stuck microphone.
About 10 seconds before automatic transmitter shutdown, a warning beep will
be heard from the speaker(s). The transceiver will automatically go to receive
mode, even if the PTT switch is continually held down. Before transmitting
again, the PTT switch must first be released and then pressed again.
When a transmission was shut down by the TOT, the GX1400 can not
transmit afterwards for 10 seconds.

9.5 BASIC OPERATION OF THE SETUP MENU

Using the setup menu, the various functions of the GX1400 series can be
customized to match the method of use. You can select the items that you
would like to adjust from the respective lists and enter or select the appropriate
settings for the intended various operation.
1. Press the [MENU] key on the operation mode
screen.
2. Press the [▲] or [▼] key to select the "SETUP",
then press the [SELECT] soft key.
3. Press the [▲] or [▼] key to select the function item,
then press the [SELECT] soft key.
NOTE
16
BUSY
P
23˚56.890N 09:56
123˚56.890W
16
BUSY
P
23˚56.890N 09:56
123˚56.890W
BACK SELECT
SETUP
DSC SETUPGROUP
CHANNEL SETUP
CONFIGURATION
BACK SELECT
USA
25W
UTC
USA
1W
UTC
25