Receiving An Individual Call - Standard Horizon Eclipse GX1400GPS Owner's Manual

6. After the ninth number has been entered, press the [FINISH] soft key.
7. Press the [▲] or [▼] key to select the operating
channel you want to communicate on and press
the [SELECT] soft key.
8. Press the [YES] soft key to transmit the individual
DSC signal.
9. After an individual call is transmitted, if the reply signal is not received,
"Waiting for ACK" is shown on the display which means the transceiver
is waiting for the vessel you called to send an acknowledgement.
To transmit the call again, press the [RESEND] soft key.
10. When the transceiver receives an acknowledgement from the vessel you
called, the radio will automatically switch to the operating channel selected
in step 9 and produce a ringing sound.
11. Key the microphone and call the other vessel you desire to communicate with.

10.4.5 Receiving an Individual Call

When receiving an individual call, an acknowledgment must be sent back to the
calling station. The transceiver in the default setting will automatically respond
to the calling station and switch to the requested channel for voice communi-
cations. Refer to the section "10.4.2 Setting up Individual Call Reply" if you
want to change the setting to see who is calling before replying to the call.
Manual reply (Default setting):
1. When an individual call is received, a ringing alarm sounds.
The display shows the MMSI or the name of the vessel transmitting the
individual call.
2. Press any key to stop the alarm.
3. Press the [ACCEPT] soft key to accept the call.
4. Press the [PAUSE] soft key to suspend the
acknowledgement.
Press the [RESUME] soft key to resume the
acknowledgement.
44
INTERSHIP CH
CH:06
CH:08
CH:09
CH:10
BACK MANUAL SELECT
INDIVIDUAL
366901555
CATEG: ROUTINE
CH: 08
Transmit a Call?
YES NO
RX INDIVIDUAL
YAESU
CATEG: ROUTINE
CH: 08
SINCE: 00:05
ACCEPT PAUSE QUIT
08
BUSY
INDIVIDUAL PAUSE
RESUME QUIT
M
USA
25W