New Leader L5034G4 Operator's Manual page 14

Header
General Safety Rules
Maintenance
READ AND UNDERSTAND MAINTENANCE PROCEDURES
Figure 3.1 - Read the maintenance and safety instructions and
understand them before performing any maintenance procedure.
Never perform any maintenance procedure or repair if the instructions
and safety procedures are not fully understood. Only trained and
qualifi ed personnel should perform any maintenance procedure or
repair.
Never modify any equipment or add attachements not approved by
Highway Equipment Company.
DO NOT SERVICE OR ADJUST MACHINE WHILE IN MOTION
Figure 3.2 - Never lubricate, service or adjust the machine or any of its
components while they are moving.
Never wear loose clothing or jewelry when working near machine
tools or moving parts.
Remove rings and other jewelry to prevent electrical shorts and other
personal injury when in contact with machine tools or moving parts.
Close and secure all guards removed for service. Check all screws,
bolts, nuts and fasteners for proper torques before operating
machine.
WEAR PROPER PROTECTIVE EQUIPMENT
Figure 3.3 - Wear close-fi tting clothing and proper safety equipment
for the job.
Always wear eye protection when working on or around the machine.
Wear a suitable hearing protection device such as earmuffs or
earplugs to protect against high decibels or loud noises.
Prolonged exposure to high decibels or loud noise can cause hearing
impairment or loss of hearing.
Wear protective gloves to protect hands from cuts, abrasions and minor burns.
305438-I
- 14 -
L5034G4
Figure 3.1
Figure 3.2
Figure 3.3
www.NewLeader.com
(800) 363-1771