Express Lpc Autocontrols - ETC Expression User's Manual Supplement

Express LPC autocontrols

8
Many new autocontrols have been created for the Express LPC.
Autocontrols enable you to access to software displays and make
settings. With the new autocontrols, you can set or change all but the
astronomic settings of the real time clock and ensure the compatibility of
remote interface devices used in a network with your LPC. Information
about each of these operations is given in the version 3.1 Express LPC
QuickGuide.
New autocontrols allow you greater access to
system software functions.
All autocontrols are executed with a 4-step procedure. For detailed
information about using autocontrols, refer to the Express LPC
QuickGuide.
An Express LPC with version 3.1 system software contains the following
autocontrols.
Autocontrol buttons
M7 / M1
M7 / (M1 and M2)
M7 / M3
M7 / (M1 and M3)
M7 / (M2 and M3)
M7 / (M1 and M2 and M3)
M7 / M4
M7 / (M1 and M5)
M7 / (M5 and M6)
M7 / (M1 and M6)
M7 / (M2 and M6)
M7 / (M3 and M6)
M7 / (M4 and M6)
M7 / (M1 and M5 and M6)
M7 / (M2 and M5 and M6)
M7 / (M3 and M5 and M6)
M7 / (M4 and M5 and M6)
M7 / (M1 and M2 and M3 and
M4 and M5 and M6)
M7 / Read From Disk
a) Convenience that enables you to back out of an
autocontrol operation without changing anything.
b) Softkeys always apply to the existing display, as
viewed on your video monitor.
Function
Stage display
Plus
Patch display
Enter
Minus
Clear
Setup display
Reboot
a
Nothing
b
Softkey [S1]
Softkey [S2]
Softkey [S3]
Softkey [S4]
Softkey [S5]
Softkey [S6]
Softkey [S7]
Softkey [S8]
Record
Read system
configuration
Express LPC autocontrols