Table of Contents
Advertisement
Real time programs
Creating real time programs
4
Part of setting the conditions under when your real time program will run,
you were able to specify days of the week. Now, in version 3.1 software,
you can specify a particular date instead.
Set a date or days of the week.
The procedure and two sub-procedures below replace the two
procedures given under Creating real time programs under Control
Interfaces in your User Manual. The following procedure sets specific
days of the week and absolute times. If you prefer to cite a specific date
rather than days of the week or referencing sunrise/sunset times rather
than absolute times, substitute using the sub-procedures provided.
Footnotes to this procedure explain where to make those substitutions.
Keystrokes:
1. Press [Setup].
2. Press [1][2] [Enter].
3. Press [S1], Select
Program, [1] [Enter].
4. Press [8][0][0] [Enter].
5. Press [1] [And] [3] [Thru] [5]
b
[Enter].
c
6. Press [5] [Enter].
7. Enter a label, then press
[Enter].
a) To reference sunrise or sunset rather than absolute time,
substitute the steps under
for step 4. Then continue in this procedure.
b) To reference a date rather than days, substitute the steps under
Referencing a date, page
procedure.
c) Labels are allowed in Express showfiles but cannot be assigned
there. To assign labels for Express showfiles, see
autocontrols, page
Action:
Selects Setup display mode
Selects Real Time Programs display
Prompt reads:
Enter time (12 hour clock)
Press [+] to enter AM or PM
Enters time to run macro.
a
Prompt reads:
Enter days of week (1=Mon, 2=Tue,
3=Wed, 4=Thu, 5=Fri, 6=Sat, 7=Sun)
or press [Days/Date] softkey again
for date
Enters days to run macro
Prompt reads:
Enter macro number
Creates real time program 1
Prompt reads:
Type program label (F6 = clear to end,
F7 = previous program label,
F8 = next program label)
Labels the real time program
Referencing sunrise or sunset, page
5, for step 5. Then continue in this
8.
5,
Express LPC
Real time programs
Advertisement
Table of Contents
