Using The Flash Deflector; Installing The Flash Deflector - Ikelite 6146.07 Instructions Manual

3. Repeat with opposite lid snap.
4. Remove the housing back.
5. If using an external strobe, install the opaque flash deflector inside
of the housing. If using the camera's built-in flash as the primary
light source, remove the flash deflector.

Using the Flash Deflector

Install the opaque white flash deflector when using external strobes.
The flash deflector improves transmission of light to the fiber optic
ports and reduces unwanted backscatter (the illumination of particles
in the water).

Installing the Flash Deflector

1. Only the diffuser or deflector should be installed at any given time.
If a diffuser is attached to the port, remove it by pulling it away from
the port. The flash deflector must be installed prior to inserting the
camera in the housing.
2. Line the velcro dots on the deflector with the velcro dots on the
inside of the housing's front. When properly aligned, the holes in
the deflector will line up with the fiber optic ports on the housing.
Velcro
3. Press the deflector firmly into place.
10