Table of Contents
Advertisement
8. Check that the set screw is oriented properly by holding the control
shaft in place on the inside of the housing while attempting to
rotate the control knob on the outside of the housing. If there is
rotation, loosen the set screw and realign with control flat; retighten
and recheck.
We do not recommend removing the control gland from the
»
housing.
Always take the housing underwater to depth without a camera
»
after removing and re-installing controls.
Remove and re-install one control at a time.
»
DO NOT pull the shutter trigger without a camera installed. You
»
may accidentally detach or damage the control spring.
Troubleshooting
Water enters the housing
•
Check and reinstall the rear o-ring.
•
Replace the o-ring if there are any signs of cracks or tears.
•
Take the housing underwater to depth without a camera installed to
ensure that the leaking has been corrected.
Photos are over-exposed (too light)
•
Adjust aperture (smaller), shutter speed (faster), or ISO (lower)
setting.
•
Move light(s) farther away from your subject.
•
Adjust exposure compensation in the camera.
•
Adjust lighting power.
22
Advertisement
Table of Contents
