Shooting Manual Flash With A Ds Strobe - Ikelite 6950.12 Instructions Manual

3. Align plug and insert into the housing bulkhead. Each male pin
mates with a female receptacle. Failing to line up the contacts
properly before tightening may result in damage to the converter
plug and/or housing bulkhead.
4. Hand-tighten the retaining ring.
5. Attach the other end of the sync cord to the bulkhead on your
strobe.
6. Turn on the strobe(s).
7. Turn on the camera. Take a test photo to ensure that your strobe(s)
are functioning properly.
A bulkhead cap or sync cord must be attached to the housing
»
for waterproof operation. Never submerge the housing without
either a sync cord or waterproof bulkhead cap attached.

Shooting Manual Flash with a DS Strobe

1. Set the camera's
2. Set the camera's
3. Press the shutter button once. The strobe will fire four short bursts.
The lightning bolt flash ready indicator will disappear from the
camera's monitor.
4. Set the DS strobe(s) on a manual power setting. Adjust the power
setting as needed between photos.
5. To revert to TTL, turn the primary strobe off and back on. Set the
camera's
18
Mode Dial
Flash Mode
Flash Mode
to "Fill in."
to "S" or "M."
to "Red eye reduction."