Table of Contents
Advertisement
4. To remove the deflector, lift the bottom with your thumb or a dull
instrument and pull away from the housing.
Installing the Camera
1. Remove any lanyard or neck strap which may be attached to the
camera.
2. Raise the camera's flash.
3. Rotate the control dial so that the flat part of the control dial pad is
aligned with the rear o-ring on the housing back.
4. Line the mounting screw up with the camera's tripod socket. Use
a coin or flat head screwdriver to tighten the mounting plate to the
camera.
5. Pull out on the housing control knobs to move them out of the way.
6. Make sure the o-ring is clean and in its proper location on the back
of the housing. The main o-ring does not require lubricant to make
a seal.
7. Align the housing back with the front and carefully insert the
camera into the housing front until the rear o-ring is touching the
front. Ensure that the control ring gear is meshed properly with the
gearing in the front of the housing.
8. Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
9. Place each lid snap into the corresponding hook on the housing
back.
10. Push the lid snaps towards the housing until they are flat against
the housing and the lock has engaged. Close opposing lid snaps at
the same time.
11. Ensure that the camera's flash is raised and pointed towards the
fiber optic ports in the front of the housing.
The camera's built-in flash cannot be raised or lowered once
»
the camera is installed in the housing.
11
Advertisement
Table of Contents
