Diffuser And Deflector Installation And Use - Ikelite 6182.70 Instruction Manual

Diffuser and Deflector Installation
A diffuser and deflector are
included with the housing. The
diffuser is white transparent plastic.
The deflector is also white but is
not transparent.
To install the diffuser or deflector,
push the "Cut-out" Section into the
port groove until it stops.
Note the Small Hole. To avoid
losing the diffuser or deflector, you
can attach a fishing line or string to
this hole.
Diffuser Use
The Diffuser should be installed when using the camera flash. When
shooting close-up photographs with the camera flash and at the camera
lens's widest angle setting, the lens port on the housing can block a
portion of the light from the camera flash. This can result in a shadow in
a lower corner of the frame. Zoom the lens to eliminate any shadow not
eliminated by the Diffuser (You can test this above water).
Deflector Use
The Deflector should be installed when using a slave unit to trigger an
external strobe. The Deflector will block and redirect the camera's flash
to an AF35 slave unit, EV-controller, or other slave unit which controls
the external strobe's output. Remove the Diffuser before attempting to
install the deflector.
Diffuser/Deflector properly
installed in port groove
Diffuser/Deflector material
Cut-out
Section
Small hole
Lens Port
13