Removing The Driven Pulley Shaft Bearing - VESPA LX 150 4T Euro 3 Service Station Manual

Engine

Removing the driven pulley shaft bearing

- Remove the clip from the inside of the cover.
- Use the specific tools to remove the bearing from
the crankcase.
CAUTION
USE AN APPROPRIATE REST SURFACE TO AVOID DAM-
AGING THE COVER PAINT.
Specific tooling
020376Y Adaptor handle
020375Y 28 x 30 mm adaptor
Refitting the driven pulley shaft bearing
- Heat up the crankcase inside with the hot air gun.
- Insert the bearing in its housing, refit the Seeger
ring.
N.B.
ALWAYS REPLACE THE BEARING WITH A NEW ONE
UPON REFITTING.
Specific tooling
020151Y Air heater
020376Y Adaptor handle
ENG - 76
Vespa LX 125 - 150 4T Euro 3