VESPA LX 150 4T Euro 3 Service Station Manual page 87

Vespa LX 125 - 150 4T Euro 3
Refitting the transmission cover
- Check that there are 2 alignment dowels and that
the sealing gasket for the oil sump on the trans-
mission cover is adequately fitted.
- Replace the cover and tighten the 10 screws to
the specified torque.
- Refit the oil loading cap/bar.
- Refit the steel washer and the driven pulley nut.
- Tighten the nut to the prescribed torque using the
lock wrench and the torque wrench tools.
- Refit the plastic cover.
Specific tooling
020423Y Driven pulley lock wrench
Locking torques (N*m)
Transmission cover screws
shaft nut
54 - 60
End gear
Removing the hub cover
- Empty the rear hub through the oil drainage tap
located inside the hub cover
- Remove the brake shoe and relevant spring
- Remove the 7 flanged screws as shown in the
figure.
- Remove the rubber cover and the brake shoes
lever sliding unscrewing the relevant retaining
screw to reach the rear of the cover
- Take off the hub cover and relevant gaskets
Driven pulley
11 - 13
Engine
ENG - 87