VESPA LX 150 4T Euro 3 Service Station Manual page 95

Vespa LX 125 - 150 4T Euro 3
Inspecting the flywheel components
- Check the integrity of the internal plastic parts of the flywheel and the Pickup control plate.
Refitting the flywheel magneto
- Fit the flywheel being careful to insert the key
properly.
- Lock the flywheel nut to the prescribed torque
- Check that the Pick-Up air gap is between 0.34
to 0.76 mm.
The air gap cannot be modified when assembling
the Pick-Up.
Different values result from deformations visible
on the Pick-Up mounting.
N.B.
A VARIATION IN THE AIR GAP DISTANCE MODIFIES THE
IGNITION SYSTEM IDLE SPEED
Locking torques (N*m)
Flywheel nut
52 - 58
Refitting the starter motor
- Fit a new O-ring on the starter and lubricate it.
- Fit the starter motor on the crankcase and lock
the 2 screws to the prescribed torque.
N.B.
REFIT THE REMAINING PARTS AS DESCRIBED IN THE
CYLINDER HEAD, TIMING, LUBRICATION, FLYWHEEL
AND TRANSMISSION CHAPTERS.
Locking torques (N*m)
Starter motor screws
Cylinder assy. and timing system
11 - 13
Engine
ENG - 95