VESPA LX 150 4T Euro 3 Service Station Manual page 163

Vespa LX 125 - 150 4T Euro 3
Refitting
- Insert the brake pads in the calliper.
- Insert the pad fixing pin and the retention screw
being careful to position the terminals of it pointing
towards the bleed screw as shown in the photo.
- Insert the clip on the pad fixing pin
N.B.
FAILURE TO RESPECT THE PAD POSITIONING REQUIRE-
MENTS WITH RESPECT TO THE DIRECTION OF ROTA-
TION COULD COMPROMISE PROPER BRAKE FUNCTION-
ING AND NOISELESSNESS.
- Keep the brake pads in contact with the pistons
and insert the calliper in the brake disc.
- Fix the calliper to the fork with the two screws with
elastic washer at the prescribed torque
- Fix the brake pipe joint to the calliper and tighten at the prescribed torque
- Purge the circuit and refit the front wheel
Locking torques (N*m)
Brake calliper mounting clamping 20 to 25 Nm Brake pipe connection 20 to 25 N•m
Braking system
BRAK SYS - 163