Steering Bearing; Removing The Rear Wheel - VESPA LX 150 4T Euro 3 Service Station Manual

Suspensions
TL 9150 066, NATO G 460 symbol

Steering bearing

Removal
- Use the specific tool both to remove the lower seat of the upper bearing and to remove the upper seat
of the lower bearing fitted on the chassis.
N.B.
TO REMOVE THE LOWER SEAT OF THE LOWER STEERING BEARING JUST USE A SCREW-
DRIVER AS A LEVER BETWEEN THE SEATING AND THE SLEEVE.
Specific tooling
020004Y Punch for removing steering bearings from headstock
- Remove the fifth wheel fitting and the dust gaiter
on the steering bearing as shown in figure, using
the specific tool. Proceed giving a few taps with the
mallet.
Specific tooling
020004Y Punch for removing steering bearings
from headstock
- Refit the fifth wheel fitting and the dust gaiter on
the steering bearing until they stop, using the spe-
cific tool.
Specific tooling
006029Y Punch for fitting steering bearing seat
on steering tube
Rear

Removing the rear wheel

-Straighten the cotter pin and remove the cap.
-Remove the wheel acting on the central fixing point.
SUSP - 156
Vespa LX 125 - 150 4T Euro 3