Table of Contents
Advertisement
Connecting an External VCR
You can connect the following external VCRs to the
VTR/CCU connector (26-pin) or the DV OUT
connector for recording.
Connector
VCR
VTR/CCU
BVW-50/50P/35/
connector
35P (portable)
Digital
DV OUT
Videocassette
connector
Recorder DSR-
20/20P/70A/
70AP/2000/
2000P, etc.
Connecting an i.LINK Digital Cassette Recorder
When you connect an i.LINK-compatible digital VCR
(such as the DSR-70A/70AP) to the DV OUT
connector of this camcorder using an i.LINK cable
(DV connecting cable), you can perform a cut editing
DSR-370/370P/570WS/570WSP
Notes
• The camcorder does not support noiseless various
speed playback.
• To protect the tape, slow playback is automatically
cancelled if the slow playback lasts for about one
minute.
Notes
• Although power can be supplied to the camcorder
Connecting cable
CCZ-A Camera
cable (max. length
10 m (33 ft.))
• The VTR/CCU connector always outputs the signals
i.LINK cable (DV
connecting cable)
(max. length
4.5 m (14 ft.))
• When no VCR is connected to the VTR/CCU
• A hub cannot be used to control a VCR connected to
or dubbing. In this case, set the camcorder's VTR
TRIGGER switch to INT ONLY.
The camcorder begins to record when a REC
command is received from the connected VCR.
DV OUT
i.LINK cable (DV connecting cable)
• When dubbing tapes using the DSR-70A/70AP, a
from an external VTR, the camcorder may not
operate correctly in some such cases, depending on
the power supply capacity of the VTR. It is
recommended that you power the camcorder from a
battery pack or from an external power supply.
from the camera. (The playback video of the internal
VCR cannot be output.)
connector (26-pin), it does not supply signals.
the DV OUT connector, because the REC command
is not transmitted to the external VCR when a hub is
used.
However, a hub can be used to control this camcorder
from an external VCR.
DSR-70A/70AP Digital
Videocassette Recorder
DV IN
continuous recorded section of approximately five
seconds is required before the recording start point. It
is recommended to record color bars or a similar
signal beforehand at the start point of the source tape
to be dubbed on this camcorder.
Chapter 2 Fitting and Connections
51
Hide quick links:
Advertisement
Table of Contents
