Sony DSR-370K1 Operating Instructions Manual page 101

Advanced menu page 3
a) For DSR-370P/570WSP: EBU75
Item
Settings
AWB MEM 2 (normal value): No
Selects whether or not correspondence with FILTER
to make the FILTER control settings. Only two
control settings (1 to 4) adjustment values (A and B) are
correspond to stored in memory.
2 × 4FL: Correspondence with
separate white
balance adjustment FILTER control settings. Each of
values stored in the four control settings can be
memory. used to set A and B adjustment
values, for a total of eight settings.
TONE ON (normal value): Outputs
Selects whether or not audio signal.
to output a 1-kHz OFF: Does not output audio
audio signal with the signal.
color bars when the
OUTPUT/DL/DCC+
has been set to
BARS.
BARS SMPTE (normal value for DSR-
Selects normal width 370/570WS): Normal width
or narrower width for EBU75 (normal value for DSR-
color bars. 370P/570WSP): EBU 75%
EBU100 (for DSR-370P/
570WSP): EBU 100%
SPLIT (for DSR-370P/570WSP):
Not for normal operation
SNG: Narrower than normal (used
for satellite communications, etc.)
REMOTE1
REC (normal value): Specifies
Sets a function for
recording start/stop.
switch 1 of the RM-
MARK: Specifies a Mark IN/OUT
LG1 connected to the
point.
REMOTE connector 1.
CUE: Specifies a Cue point.
NG: Specifies NG/OK.
REMOTE2
REC: Specifies recording start/stop.
Sets a function for
MARK (normal value): Specifies
switch 2 of the RM- a Mark IN/OUT point.
LG1 connected to the CUE: Specifies a Cue point.
REMOTE connector 1. NG: Specifies NG/OK.
BAUD RATE
9600, 38400 (normal value)
Sets a baud rate for a
computer connected
to the REMOTE
connector 2 (to be
supported in the future
version).
iLINK CTL
REC/P (normal value): When an
Selects whether to external VCR is recording or
control from the recording paused, control from the
camera the start and camera according to the setting of
stop of recording by the VTR TRIGGER switch.
the external VCR
ALL: When an external VCR is
connected to the DV
recording, recording paused, or
OUT connector.
stopped, control from the camera
according to the setting of the VTR
TRIGGER switch.
For the DSR-1500/1500P/1600/
1600P/1800/1800P/2000/2000P,
which cannot be set to recording
paused, set this item to ALL.
OFF: Do not control from the
camera.
Chapter 4 Viewfinder Screen Indications and Menus
101