Table of Contents
Advertisement
Connections
Connecting the DSR-70/70P Digital Videocassette Recorder
You can do cut editing and digital dubbing by
connecting the DSR-70/70P with the optional DSBK-
140 fitted, using an i.LINK cable (DV connecting
cable).
DSR-300A/300AP
Notes
• The camcorder does not support noiseless various
speed playback.
• To protect the tape, slow playback is automatically
cancelled if the slow playback lasts for about one
minute.
Connecting an External VCR
You can connect the following external VCRs to the
VTR connector (26-pin) or the DV OUT connector for
recording.
Connector
VCR
VTR connector
BVW-50/50P/35/
35P (portable)
VTR connector
VO-8800/6800
(U-matic)
Digital
DV OUT
Videocassette
connector
Recorder DSR-
20/20P/70/70P/
2000/2000P, etc.
46
Chapter 2 Fitting and Connections
DSR-300A/300AP begins recording when the DSR-
70/70P or other recorder sends a REC command.
DV OUT
i.LINK cable (DV connecting cable)
• When dubbing tapes using the DSR-70/70P, a
Notes
• There is no power supply connection between the
Connecting cable
• The VTR connector always outputs the signals from
CCZ-A Camera
cable (max. length
10 m (33 ft.))
CCZQ-A Camera
cable (max. length
• When no VCR is connected to the VTR connector
10 m (33 ft.))
i.LINK cable (DV
connecting cable)
(max. length
4.5 m (14 ft.))
DSR-70/70P Digital
Videocassette Recorder
DV IN
continuous recorded section of approximately five
seconds is required before the recording start point. It
is recommended to record color bars or a similar
signal beforehand at the start point of the source tape
to be dubbed on this unit.
camcorder and VCR. Provide separate power
supplies.
the camera. (The playback video of the internal VCR
cannot be output. Also, a CCU connection cannot be
made.
(26-pin), it does not supply signals.
Advertisement
Table of Contents
