Sony DSR-370K1 Operating Instructions Manual page 93

Basic menu page 2
Item Settings
SKIN DTL 0.0 to 0.5 (normal value) to 1.0
Sets the amount of Smaller values set a softer skin detail.
skin detail
correction.
DL LEV LOW, STD (normal value), HIGH
Sets the Set the amount of DynaLatitude
DynaLatitude level. effects as high level, standard level
(STD), or low level.
When the filter is 3200 or CROSS:
PRE WHT
Sets the color 2200 to 3200 (normal value) to 4300,
temperature of the filter 5600K, 5600K + 1/8ND
When the filter is 5600K + 1/64ND:
preset white
4600 to 5600 (normal value) to 12000
balance.
Basic menu page 3
This is displayed when the SETUP switch has been set
to FILE.
For details of this operation, see "Setup Files" (page 108).
Basic menu page 4
This is displayed when the optional DSBK-501/501P
Analog Composite Input Board is fitted to the
camcorder.
Item Settings
CAM (normal value)
VIDEO
Records the signal shot by this camcorder.
IN
Selects
EXT
the
Records the signal input from the GEN LOCK IN/
signal
VIDEO IN connector. The image on the
to be
viewfinder and the signal output from the
recorded
MONITOR OUT connector are switched to the
onto the
external video signal. When inputting the external
internal
video signal, "EXT INPUT" blinks on the screen.
VCR.
If you set VIDEO IN to EXT and input the external
VBS signal from the GEN LOCK IN connector, the
image in the viewfinder and the signal output from the
MONITOR OUT connector are switched to the
external video signal. When inputting the external
video signal, "EXT INPUT" always blinks on the
screen.
Notes
• When VIDEO IN is set to EXT, the video signals are
not output from the S VIDEO OUT connector.
• When VIDEO IN is set to EXT, the basic menu page
5 is not displayed.
• This page is not displayed when a CCU (camera
control unit) is connected.
Chapter 4 Viewfinder Screen Indications and Menus
93