Upc-A - geos SD 580 2D Setting Manual

14. UPC-A

UPC-A On/Off
*On
UPC-A Check Digit
This selection allows you to specify whether the check digit should be transmitted at the
end of the scanned data or not. Default = On.
* On
UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the beginning of
the scanned data, but the unit can be programmed so it will not transmit it. Default = On.
*On
UPC-A Addenda
This selection adds 2 or 5 digits to the end of all scanned UPC-A data. Default = Off for
both 2 Digit and 5 Digit Addenda.
2 Digit Addenda On
41
GEOS SD 580 2D
Default UPC-A setting
Off
Off
Off