Code39 - geos SD 580 2D Setting Manual

3. Code39

Code39 On/Off
* On
Code39 Start/Stop Characters
Start/Stop characters identify the leading and trailing ends of the bar code.
You may either transmit, or not transmit Start/Stop characters. Default = Don't
Transmit.
Transmit
Code39 Check Character
No Check Character indicates that the scanner reads and transmits bar code data with
or without a check character. When Check Character is set to Validate, but Don't
Transmit, the unit only reads Code 39 bar codes printed with a check character, but will
not transmit the check character with the scanned data. When Check Character is set to
Validate and Transmit, the scanner only reads Code 39 bar codes printed with a check
character, and will transmit this character at the end of the scanned data. Default = No
Check Character.
*No Check Character
29
GEOS SD 580 2D
Recall Default
Off
* Don't Transmit