Reread Delay - geos SD 580 2D Setting Manual

GEOS SD 580 2D
(if there have been no further trigger pulls) the scanner reverts to the original
presentation mode. Scan the Presentation Time-Out bar code, then scan the time-out
duration (from 0-300,000 milliseconds) from the inside back cover, and Save. Default =
5,000 ms.
Presentation Time-Out
12. Read Time-Out
When the scanner is in manual trigger mode, if the scanner could not decode the
pictures, it will continue decode it until reach the decode time-out. The default decode
time-out is 30,000ms. Scan the Read Time-Out bar code, then scan the time-out
duration (from 0-300,000 milliseconds) from the inside back cover, and Save.
Read Time-out

13. Reread Delay

This sets the time period before the scanner can read the same bar code a second time.
Setting a reread delay protects against accidental rereads of the same bar code. Longer
delays are effective in minimizing accidental rereads. Use shorter delays in applications
where repetitive bar code scanning is required. Reread Delay only works when in a
Presentation Mode. Default = 750ms.
500ms
750ms
1000ms
2000ms
If you want to set your own length for the reread delay, scan the bar code below, then
set the delay (from 0-30,000 milliseconds) by scanning digits from the inside back cover,
20