Input/Output Configuration; Power Up Beeper; Power On Belcharacter; Trigger Click - geos SD 580 2D Setting Manual

IV、input/output configuration

1. Power Up Beeper

The scanner can be programmed to beep when it's powered up. If you are using a
cordless system, the base can also be programmed to beep when it is powered up.
Scan the Off bar code(s) if you don't want a power up beep. Default = Power Up Beeper
On - Scanner.
*Power Up Beeper On

2. Power On BELCharacter

You may wish to force the scanner to beep upon a command sent from the host. If you
scan the Beep on BEL On bar code below, the scanner will beep every time a BEL
character is received from the host. Default = Beep on BEL Off.
Beep On BEL On

3. Trigger Click

To hear an audible click every time the scanner trigger is pressed, scan the Trigger
Click On bar code below. Scan the Trigger Click Off code if you don't wish to hear the
click. (This feature has no effect on serial or automatic triggering.) Default = Trigger
Click Off.
。
Trigger Click On
14
GEOS SD 580 2D
Power Up Beeper Off
*Beep On BELOff
*Trigger Click Off