Aimer Light - geos SD 580 2D Setting Manual

then scanning Save.
14. Illumination Light
If you want the illumination lights on while reading a bar code, scan the Illumination
Lights On bar code, below. However, if you want to turn just the lights off, scan the
Illumination Lights Off bar code. Default =Illumination Lights On.
*Illumination Light On

15. Aimer light

If you want the aimer lights on while reading a bar code, scan the Aimer Lights On bar
code, below. However, if you want to turn just the lights off, scan the Aimer Lights Off
bar code. Default = Aimer Lights On.
The aimer delay allows a delay time for the operator to aim the scanner before the
picture is taken. Use these codes to set the time between when the trigger is pulled and
when the picture is taken. During the delay time, the aiming light will appear, but the
LEDs won't turn on until the delay time is over. Default = Off.
Aimer lights Off
Aimer delay
The aimer delay allows a delay time for the operator to aim the scanner before the
picture is taken. Use these codes to set the time between when the trigger is pulled and
when the picture is taken. During the delay time, the aiming light will appear, but the
LEDs won't turn on until the delay time is over. Default = Off
200ms
21
GEOS SD 580 2D
Reread Delay
Illumination Light Off
*Aimer light On