Skyrc T200 Instruction Manual page 28

System Setting
ITEM


N i M H S e n s i t i v i t y

D . P e a k D e f a u l t


N i C d S e n s i t i v i t y


D . P e a k D e f a u l t
K e y B e e p
B u z z e r
D C I n p u t L o w
C u t - O f f
1 1 . 0 V
L o a d F a c t o r y S e t
E n t e r
V e r s i o n
H W : 1 . 0 0 F W : 1 . 1 0
· 26
SELECTION
Default: 4mV/Cell
3-15mV/Cell
O N
OFF/ON
O N
10-12V
DESCRIPTION
This program is for NiMH/NiCd battery
only. When the charger detects the delta
peak value reaches the value you set, the
charger will say the battery is fully
charged.
The beep sounds at every time touching
the buttons to confirm your action. The
beep or melody sounded at various times
during operation to alert different mode
changes.
There will be error message when DC
input voltage is lower than the reset value.
Press ENTER to load factory default
setting.
It indicates the hardware and firmware
version.
T200