Skyrc T200 Instruction Manual page 19

NiMH Auto CHARGE
CURRENT 1.3A
START/ENTER
NiMH 1.3A 5.42V
AUT 002:22 00106
NiMH/NiCd Discharge Mode:
NiMH DISCHARGE
1.3A CUT:9.6V
NiMH 1.3A 10.42V
AUT 002:22 00106
T200
NiMH/NiCd Battery Program
After selecting the correct battery type, use the INC or DEC
button to change the charge mode to the "Auto CHARGE"
setting.
Press the START button and the amp rate value will begin
flashing. Use the INC or DEC button to adjust the value to
the desired rate. Follow the instructions provided on your
battery when setting the upper charge amperage rate.
Press and hold the START button for 3 seconds to start charging.
Once charging has commenced, the charger will display the
following real-time information: battery type, charging
current, battery voltage, elapsed time and charged capacity.
Once the battery is fully charged, the screen will read "END:
FINISHED" and the charger will emit a ringing sound. You
can press the STOP button at any time during the charging
process to stop charging.
After selecting the correct battery type, use the INC or DEC
button to select the "DISCHARGE" mode. Press the START
button and the amp rate value will begin flashing. Use the
INC or DEC buttons to adjust the value to the desired
discharge rate. Press the START button again and the
voltage cut-off will begin to flash. Use the INC or DEC button
to adjust the value to the desired rate.
Follow the instructions provided on your battery when setting
the voltage cut-off. The T200 will stop discharging when the
battery has reached the preset voltage cut-off.
Press and hold the START button for 3 seconds to start
discharging. Once discharging has commenced, the charger
will display the following real-time information: battery type,
discharging current, battery voltage, working mode,
elapsed
time and discharged capacity.
17 ·