Skyrc T200 Instruction Manual page 20

NiMH/NiCd Battery Program
[ TIME: 00:04:04 ]
9.6V 00640mAh
NiMH/NiCd Re-Peak Mode:
Applicable to NiMH and NiCD batteries only, in re-peak mode the charger can peak-
charge the battery once, twice, or three times in a row automatically. This process is
good for confirming that the battery is fully charged and for verifying how well the
battery can accept a fast charge. A five-minute cool-down delay occurs after each re-
peak charge.
IN RE-PEAK MODE, THE T200 USES THE CHARGE AMPERAGE AND VOLTAGE
SETTINGS ENTERED IN CHARGE MODE.
NiMH RE-PEAK
2
START/ENTER
NiMH 1.3A 10.42V
RPC 004:04 00686
· 18
When discharging is complete, the screen will read "END:
CUTOFF-VOL" and the charger will emit a ringing sound.
The charger will display the elapsed time, end voltage and
the discharged capacity in mAh.
You can press the STOP button at any time during the
discharging process to stop the discharge process.
After selecting the correct battery type, use the INC or DEC
button to select the "RE-PEAK" mode. Press the START
button and the Re-peak cycle number 1 begins to flash on
the screen. Use the INC or DEC button to scroll through the
cycle count and set a number between 1 and 3.
Press and hold the START button for 3 seconds to start the
re-peak process.
Once the Re-Peak process has begun, the charger
will display the following real-time information: battery
type, charging current, battery voltage, elapsed time
and charged capacity.
Once the Re-Peak process has completed, the
screen will read "END: RE-PEAK" and the charger
will emit a ringing sound. The charger will display the
charge/discharge capacity for each cycle. Using the
+ and - buttons, you can scroll through the history
data of each cycle.
T200