Playback - Basics; Playing Back Tape - Sony DCR-TRV19 Manual de instrucciones / Manual de instruções Operating Instructions Manual

— Playback – Basics —

Playing back tape

You can monitor the recorded tape on the LCD screen. If you close the LCD panel, you
can monitor the playback picture in the viewfinder. You can also control playback using
the Remote Commander supplied with your camcorder.
(1) Set the POWER switch to VCR while pressing the small green button.
(2) Press OPEN to open the LCD panel.
(3) Press
(4) Press
(5) Adjust the volume following the steps below.
1 Press FN to display PAGE1.
2 Press VOL. The screen to adjust volume appears.
3 Press – (to turn down the volume)/+ (to turn up the volume).
4 Press
3
2
To return to FN
Press EXIT.
To cancel playback
Press .
To rewind the tape
Press during playback stop.
To fastforward the tape
Press during playback stop.
To view a still image (playback pause)
Press during playback. To resume playback, press
pause lasts more than 5 minutes, the camcorder automatically switches to the stop
mode.
If you leave the power on for a long time
Your camcorder gets warm. This is not a malfunction.
to rewind the tape.
to start playback.
OK to return to PAGE1.
4 1
POWER
VCR
OFF ( CHG )
CAMERA
MEMORY
5
VOL
The bar indicator
again. If the playback
OK
39