Sony DCR-TRV19 Manual de instrucciones / Manual de instruções Operating Instructions Manual page 99

Audio dubbing
Adding an audio sound on the recorded tape
Choose a connection mentioned on page 97, and connect audio equipment or
microphone to your camcorder. Then follow the procedure below.
The POWER switch should be set to
Operate by touching the panel.
(1) Insert the recorded tape into your camcorder.
(2) Locate the recording start point. Press
playing back, press
recording start point by pressing
(3) Press FN and select PAGE3.
(4) Press A DUB CTRL.
The A DUB CTRL screen appears.
(5) Press AUDIO DUB. The green
(6) Press
audio you want to record.
The new sound is recorded in stereo 2 (ST2) during playback. While recording
new sound, the red
(7) Press
You cannot perform audio dubbing:
•On the tape recorded in the 16-bit mode
•On the tape recorded in the LP mode
•When the DV Interface is connected
•On blank portions of a tape
•When the write-protect tab of the cassette is set to lock
To add new sound to previously recorded sections more precisely
During playback, press ZERO SET MEMORY at the point where you want to stop
recording new sound.
Follow the procedure on page 75. Recording automatically stops at the point where
ZERO SET MEMORY was pressed.
We recommend that you add new sound on the tape recorded with your
camcorder
If you add new sound on the tape recorded with another camcorder (including other
DCR-TRV19/TRV22/TRV33), the sound quality may become deteriorated.
at the recording start point. You can fine adjust the
A DUB CTRL
REC REC REC REC REC REC REC
PAUSE PAUSE PAUSE PAUSE PAUSE PAUSE PAUSE
on your camcorder and at the same time start playing back the
indicator appears on the screen.
on your camcorder at the point where you want to stop recording.
.
to start playing back. To pause
/ .
RET. RET. RET. RET. RET. RET. RET. RET.
AUDIO REC REC REC REC REC REC REC
START START START START START START START DUB
X indicator appears on the screen.
99