Table of Contents
Advertisement
Test run
1
Check power supply voltage
2
Turn the ground-fault circuit interrupter on
Turn on power by using the means for
3
disconnection
4
Turn the power switch on
5
Dry hands
Turn the air speed knob while inserting the
6
hands.
Turn on the heater switch.
7
8
*
Do not turn the power switch on with your hands inside the Hand-drying area.
*
Turn the power switch off if the check lamp in the display is either on or blinking, and then turn the power back on 40 seconds
after you've made sure all the lamps in the display are off.
Step
Is single-phase alternating current 120V being used?
Is the power lamp in the display on ?
Is the air blowing?
Does the air speed change?
Is the heater lamp illuminating at the display?
blows after turning on the switch.)
the heater may be felt at the start of use but this is normal
and there is no problem.)
Is the unit mounted securely without any vibration or noises?
What to check for
Does hot air blow out? (It takes a few minutes before hot air
(Burning smell of oil, dirt, etc. at the heat storage section in
Check
7
Advertisement
Table of Contents
