Test Run - Mitsubishi Electric Jet Towel JT-SB116JH-G-NA Installation Manual

Test Run

Step
1 Check the power supply voltage
Turn the ground-fault circuit
2
interrupter is "ON"
3 Maintenance switch is "OFF"
Insert your hands to check if air is
4
being blown.
Insert your hands to check if warm
5 air is being blown.
(When the heater is "ON".)
6
※ Do not turn the maintenance switch off while hands or other objects are inside the hand drying area.
※ If the display lamp fl ashes, turn the breaker off, check that all of the lamps on the display section are off, and then wait
for 1 minute before turning the breaker back on.
What to check for
120 Vac power being used?
Incorrect power supply may cause malfunctions.
Is the air blowing?
Is warm air blowing?
( If the room temperature is above 86ºF(30ºC), for safety
reasons the heater will not operate even if the heater
switch is turned on.）
※ As the heater is a simple heater, if the room temperature
is less than 64ºF(18ºC), the air may feel cold.
Is the heater lamp in the display on?
Is the unit mounted securely without any vibration or
abnormal noises?
− 12 −
Check