Mitsubishi Electric JT-SB116EH-W-CA Installation Manual page 6

Installation (Continued)
Make wiring on the terminal block.
(1) Remove the wire sheath for 15 mm from the end.
(2) Connect the ground wire using the ground screw,
provided at the right side of the terminal block, and
washer.
●
Use the washer at the position as illustrated at right.
(3)
Screw-tighten the power cord to the terminal block
securely.
5
(4)
Check, by pulling the wires, that they are securely fixed to
the terminal block.
Install the terminal cover.
(1)
Run the power cord and wires through the rubber bushing.
Then use the mounting screw to back the terminal cover on
the unit again.
Install the attached clip on the power cord, and then fix it
(2)
with the clip mounting screw.
(3) Confirm that the power cord and wires are not pinched
anywhere.
6
●
Front panel cannot be installed if the wires are placed on
the terminal cover. Place the wires to the right side of the
cover.
1. Install the front panel
(1)
Engage the groove of front panel on the unit.
(2) Using the removed screws (2 pieces), install on the unit as it was.
(3) Confirm that the front panel is fitted securely.
2. Attach the drain tank.
7
6
Terminal cover
mounting screw
Terminal cover
Front panel
Front panel
mounting screws
Drain tank
Terminal block
Power cord
Washer
Ground wire
Ground screw
Terminal block
Power cord
Clip + Clip mounting screw
(Accessory)
Unit