Do not install in the following types of location, as this may cause malfunction.
Locations where the temperature could be lower than 0˚C or higher than 40˚C.
Locations where the humidity could be lower than 5%RH or higher than 95%RH.
Locations where the unit may come into direct contact with water.
Locations where the unit is under direct or strong sunlight. (May cause sensor to malfunction.)
Locations where there is a lot of condensation.
Locations where corrosive, neutral, or reductive gases are present.
Locations where salt damage may occur.
Vehicles (incl. vessels, trains.)
Install the unit somewhere easy to use, as shown below.
If the unit is installed too low, water may get on it when the floor is being cleaned.
If water gets inside, it may damage the unit or moisten the sound-absorbent material, leading to bacterial growth.
The left side of the unit must be at least 150 mm away from any walls, as that is where the power switch is located.
Ensure there are no mirrors or walls near the right side, as drops of water may splash when drying hands.
(We recommend a distance of at least 100 mm.)
Avoid locations where people or doors might bump into the unit.
Choose a completely flat surface on the wall to install the unit.
If the wall is not concrete, reinforce it before installation.
Avoid to install the unit any place where foods, tableware, or the likes are handled nearby because water may
Do not embed the unit in the wall.
Make sure to secure distances larger than those listed below away from walls of building, etc.
Power controll section
He at er
Air sp ee
Po w er
1 5 0
Installation panel screw
1 0 0
1 4 0
Recommended installation heights:
Men: 940 mm
Women: 920 mm